Georgia Off Road Visit Highland Park
Not logged in.
Member Login
Not Registered?
Home
News
Forums
Calendar
Ladies
Gallery
Track Map
MX Tracks
ORV Trails
Dirt Bike Guide
Reviews
Dealer Guide - our own yellow pages!
Contact GOR Administrators
Georgia Offroad

Create Your Badge


1981 Yamaha IT465
Show All Dirt Bikes
Go back to the Yamaha IT list

1981 Yamaha IT465

Date Added March 21, 2000

Page Views

8,890

Reviews

Read 3 Reviews
Write a Review

Average Rating

93/100

Photos

1

Specifications

No

1981 Yamaha IT465 Reviews
Joe Reitman


Joined: 11/16/2003
Posts: 11201
Location: Morgan County Georgia

Posted: Mar 2, 2009 1:14 PM   Back to Top
An article I just found on thumpertalk (Score:1)
Power
The IT465 engine is a direct adaption from the YZ465 motocross engine. The motors share a common crank, cumbustion chamber, clutch and bore and stroke measurement. The difference lies in the heavier flywheel on the IT (to run the lights), the different internal gearing (gears are wider, taller and longer), smaller carburetor and more restrictive exhaust pipe (because of the spark arrestor). Where the YZ465 is slightly peaky, and revs very quickly, the IT, thanks mainly to the flywheel and exhaust, has changed the brutal 50 horsepower machine into a cooperative racer. The powerband in long, flowing and gradual-but it still retains a lot of muscle.
As you might suspect, the abundance of low-end torque seems to have no basement level. You can almost snap your neck by dropping the clutch at slightly above idle. In one enduro, while plonking at a snail’s pace through a water-melon size rock section, we realized that the bike was going less than 10 mph, yet was content to stay in third gear and still pull strongly.
The majority of enduro riding, the “tight stuff” requires precision and control to get through it quickly. The IT465, thanks to its great power-plant, allows you to select lines and directions with the throttle. By keeping the motor in the sub-5000 rpm range, the bike reacts and responds as though it’s driven by an electric motor. Engine response is smooth, strong and never lacking in horsepower.
It wasn’t until we’d ridden the IT465H over 400 miles that we realized just how often the bike was ridden at or near half throttle. A friend questioned us about the top end power. We had to admit that we really didn’t know. Not because we weren’t going fast enough to find
http://groups.msn.com/_Secure/0SwDpAiEXBnPKIL5xpPfp4cPTEzk2vxM7UK1AdpOTGx0PeIzk0 AQZeoQBHT8g6tvEHKuYegymlFWSpmyHzgdwM2BYRr!2QkJekhr puKIGXOfGP!phd8Ioew/it465Hpic2.jpg
out-it was just that the bike was so cooperative in low end power that we never really tapped whatever lies at wide open throttle.
The only problem we had adapting to the engine was in tight corners. The heavy flywheel carries a lot of weight and enertia, and one gets used to depending on the engine to be always running. But sometimes, especially during hard braking, the engine will die. Pulling the clutch in for tight corners solved the problem for us, but it was still a little while before we stopped relying on the engine always being there and constantly pumping out the torque. It seems as reliable as the sun-but on occasion the rider gets so confident that the motor will always be there that it comes as a surprise when it dies.
If the gearbox ratios have any flaws in progression or spacing, you’d be hard pressed to find them. The engine pumps so strongly that it could easily cover any blemishes in gear ratios. Although on a few occasions we found ourselves slipping the clutch when moving from a near dead stop in second or third gear, for the most part you could pick a gear and stay in it-for miles.
Ergonomics
this article in a Trail Bikes magazine. Enjoy!
http://groups.msn.com/_Secure/0SwDiAiAXxnLKIL5xpPfp4XNg*LFR5vKGd4IZG8CXQ0cBg*J!V T7J0ZzVyuBTsfxNb2bJeNx3!LIJneIj3y6KXOV5Yz2yQNsowHC xrD!*H!C30!9i3QP0VA/it465Hpic1.jpg
When we first sat down to plan a list of motorcycles to test for this magazine, two bikes went on the “must ride” list. The Kawasaki KDX175, because it’s probably the finest lightweight motorcycle designed, and the Yamaha IT465H.

The most impressive and awesome component of the IT465 is the engine. After six years of big bore enduro bike manufacturing, Yamaha has come up with a combination of powerplant components that are extremely well suited for enduro racing.
Suspension, Front
Yamaha has used its adjustable suspension on the IT465H. The front forks are air/oil and spring units which allow great versatility in presure and oil levels. The rear shock has 24 different damping settings and a large range of spring preload adjustment.
The suspension, depending on where and how fast you ride, can be good or “almost good.” Woods riders will find the suspension very close to being dialed in. A little extra oil and air in the forks will keep most “A” riders happy about the front. Seeting the adjustable monoshock damper in one of the light settings, and using the Yamaha accessory firm shock spring will reward most woods riders with good suspension. The shock’s 24 position damping adjuster can be dialed in with a little seat of the pants tuning and a couple hours of
http://groups.msn.com/_Secure/0SwDXAiMXhnPKIL5xpPfp4d*Wb2u34XwHlVjZBq7FzVyn3lPBx y2zo0vJqLvj6ZOpLrIZiU5m8Q1am04zTvMHn07jQllY6Szi7Nd nSct8F6R9fGTSbLjCsQ/it465Hpic4.jpg
fiddling. Most riders who use the bike for weekend fun will most likely be very satisfied with the standard suspension.
Desert enduro racers, or the ultrafast woods racers who prefer Its will want a little more from the 465’s suspension. We found a very good suspension system offered by White Brother Cycle Specialties. Their fork kit and shock modification will upgrade and refine the IT465H to put it on par with any other National Enduro winning mount. With suspension increased from 10.6 to 11.8 inches travel the bike is a little tall and can be a handful in tight sections where you’re always putting your foot out to steady yourself. It’s a small compromise considering how well the suspension works on other portions of race courses.
Suspension, Rear
The modified shock is tamed down, through the use of different damping washers in the internal shock body, and a unique cross-over dual spring system. The front forks received a complete damper rod and spring fork kit, which increased travel (again to 11.8 inches), speeded up the reaction of the forks and eliminated the harsh bottoming-out feeling.
Brakes

Fortunately it has brakes that are very capable of stopping the weight. The front wheel has a dual leading shoe system-almost twice as effective as traditional drum brakes. It’s hard to adapt to that much brake-we went over the bars a couple of times because we squeezed too hard on the front brake. Once it gets slightly glazed and the rider adapts, you’ll forever disdain any other brake. It’s more than adequate when it comes to hauling down to a crawl.
The front brake’s flawless performance compensates for the rear brake. Because of the rear wheel quick change system (requiring only 5 seconds to remove) the back brake is not a floating brake system and uses the swingarm as a backing plate.
http://groups.msn.com/_Secure/0SwDXAiIXRnPKIL5xpPfp4QQQFrPYEMRElbTU5jTw3UYrhRab9 q6e6hPX8q4N!1rtbvQwIT4tkqjTNo38fODPs7patgLA3MZ8lOG DCFAWjIO8LoNWlvHsgg/it465Hpic3.jpg

The brake is interrupted by suspension movement, and will chatter and lock when you’re looking for the same precision that the front offers. You can adapt, but it would be nice if the rear worked as well as the front.
Comments
Towards the end of our tests we realized that many of these Its will never see an enduro event. They’ll be ridden out in the back hills by weekend trailriders. It’s going to be “the bike” of big bore enthusiasts. The world is getting around about the IT465H. People are discovering that it climbs any hill you can find, regardless of the presence or absence of a trail. It stops well, handles handsomely despite it’s weight and for most people has enough adjustments in its suspension system to make for a plush day’s ride.
The IT465H is going to be a very successful enduro machine and even more popular weekend playbike. The combination of abundant horsepower, good all around suspension, nice handling and Yamaha reliability will result in brisk IT465 sales. And why not? It’s a great racing mount and an even better weekend warrior.
Rating
90
Rider Height / Weight / Skill
6'1" / 180 / Intermediate
Log in to report abuse

helmwig
Legacy Account

Reviews: 2

Registered:
Jun 1, 2002

Send Email Email

Posted: Jun 1, 2002 5:45 AM   Back to Top
Legacy Review (Score:1)
Power
Hy!
<br />

<br />
I was a happy owner of a Yamaha IT465 (year 1982)
<br />
There were only 5 bikes imported to Austria (Europe) and I was one of the 5 happy owners of this bike.
<br />

<br />
Unfortunately, this bike was stolen in March 2002, and there is no other bike still running here.
<br />

<br />
I think this bike was sold in Canada, France and mostly in Amerika.
<br />

<br />
If you know where to buy one, I would be very happy to get it and to ship it to Austria.
<br />

<br />
I would prefer a running one (if possible).
<br />

<br />
Can someone help me??
<br />

<br />
Greating from Austria,
<br />

<br />
Helmwig
<br />

<br />
Suspension
dont know
Brakes
dont know
Rating
100
Log in to report abuse

Book
Legacy Account

Reviews: 1

Registered:
May 17, 2001

Send Email Email

Posted: May 17, 2001 8:20 PM   Back to Top
Legacy Review (Score:1)
Power
alot of power
Suspension
what goes up must come down, and this one comes down hard.
Brakes
excellant
Comments
Me and my dad ride it, and i think its a great bike.Where can i get another one.
Rating
90
Log in to report abuse

Keywords: 1981, Yamaha, IT465, , 1981 Yamaha IT465 , IT, 465, review, rate, opinions, photo, image, specifications, Dirt Bike Guide, GOR, georgiaoffroad.com

 







Northeast Georgia Motorsports
Hyperformance Cycles - Woodstock, GA
KTM Parts
Off Camber Riders Association
Honda Rider Education Center